Paper quilling Basic Shapes & Techniques tutorial

As a beginner to paper quilling techniques, I have been using a split head tool to make my paper coils. I noticed that my coil centres are not very tidy which makes the overall effect unprofessional. So I tried to roll the strip just with my fingers like Asmah of  Simple Rhyme but just couldn't get the hang of it. Then I thought perhaps a needle tool might be better. Again I couldn't get the paper to roll properly. As always, I searched youtube to see if there was a simple tutorial. I was lucky to find the tutorial below by Claire Sunok Choi (paper6262). I have tried this method and it works! Using a tweezer to control the coil is such a good idea. Now my coil centres are so neat and its really fast to do as well. Claire has also done other videos which are equally good. Hope you find this video helpful.

Iris Folding

I thought I would try out Iris Folding for a change. For those who have not heard about this, Iris Folding is a paper folding technique that originated in Holland. It is done with coloured strips of folded paper and a template/pattern. You will need an aperture that fits your template/pattern. The strips of folded paper are taped into placed over the pattern, creating a spiralling design that apparently resembles the iris of an eye or camera. Although basic Iris Folding is simple, you can get stunning results from the choice of paper used. Just check online and you will see thousands of beautiful examples. Some experienced crafters have taken it a step higher and created very intricate designs that are a bit more involved.

To begin, I chose a heart pattern that I downloaded from Gemscottage. The most difficult part was cutting the aperture. It is possible to buy ready cut apertures of various patterns but sadly I have not come across them in Malaysia yet. Lay the aperture card over the pattern with the wrong side facing you. Fix to the pattern with tape. I cut the papers about 24mm wide (length can be as long as the paper you are using). Then fold the paper into two, using a bone folder to give a crisp neat edge.

Turn your card over to the wrong side and tape to pattern

Pattern visible through aperture, sorry for the bad photo

 After that it is a matter of following the numbers on the pattern. Take a folded strip and place on the first section, the folded edge should be against the line of the pattern. Trim each end of the strip so that there is a bit of overlap over the edge of the aperture, about 5mm on either side. Fix the strip to the card with small pieces of tape at each end. Work around the pattern adding the different strips in sequence until your design is complete.

Oops, the photo above is what I did in the beginning before I realised that I must add the strips in sequence ie do all the lines numbered 1a, 1b, 1c first, followed by the 2a, 2b,2c, then the third sections and so on. I peeled the strips off and started again but forgot to take a photo. Sorry!

All strips added, square piece of paper stuck over the centre

The small hole left in the middle of the design can be covered with a flat piece of paper in a colour of your choice. Once completed, you will need to stick a piece of paper or card over it so it is nice and tidy. By the way, you can either cut the aperture directly on the greeting card or you can do it on a separate card and then mount the completed design on the front of your greeting card. Now turn over to see the completed design.

This is what it looks like on the front

I will add some embellishments to finish off the card. Will post when completed. I think it will make a nice wedding card. Hope you enjoyed this and you give Iris Folding a try. It is quite relaxing. Don't forget to look at the gorgeous examples on the web, you will be amazed. Loads of free patterns available as well - thanks to generous crafters. Thanks for popping by! xx